The system's BFO was developed following successful testing of the receiver's front-end and mixer circuitry.

The BFO injects signals into both the receiver-section's product detector as well as the transmitter's balanced modulator.

This photo shows the initial Manhattan wiring of the BFO board. The BFO's buffer uses the same shunt-feedback two-stage direct-coupled configuration used in the VFO buffer.

Click to see the schematic of the BFO.  
The Tribulations of a SPICE Simulation

As the circuit for the BFO evolved, it was decided to perform a SPICE simulation to see how the oscillator might behave, prior to melting any solder.

The simulation was attempted by capturing the schematic using Electronics Workbench's Multi-Sim program v6.11 PowerPro for Windows. Click here to view the schematic for the BFO as captured in Multi-Sim.

Interestingly, regardless of what Multi-Sim piezo crystal model was selected for the oscillator's crystal, none of the Multi-Sim simulations would "oscillate."

Apparently, the simulated oscillator was too perfect; there were no imbalances to get oscillation started! In a real world oscillator, transistor and component noise, as well as power supply variations during initial power-up, are generally sufficient to get oscillation under way. It's akin to pushing a pendulum for the first time on a grandfather clock. In this case, the power supply "spring" was wound, but the circuit needed a "pendulum push."

After consulting with K8CN, Mike (a teacher who uses Multi-Sim in his classroom), it was decided to tack a crude virtual 12-V momentary switch to the crystal. You can see this pushbutton in the upper left-hand corner of the SPICE drawing.

Lo and behold---one push of the spacebar "button" and the circuit broke into virtual oscillation.

Depending on the CAE program's virtual oscilloscope settings, the initial start-up swings were even visible, and you could see the circuit settle into a steady oscillation state. Here's the image of the simulated oscillator's output waveform during normal operation.

Click here for a short article in "Planet Analog" that I wrote about this adventure, as well as an additional interesting screen capture.

Click to continue to see the BFO hardware.

Use your Browser's BACK button to go back.

Click here to return to home page.