Elecraft K3 Software

K3_EZ - VERSION 2.0.0.5   (August 24, 2009)

• Band stack 'registers' - with AGC Presets
• Frequency Memories
• Equalizer Manager
• Configuration Helper
   

5 frequency save areas by band and mode, direct frequency entry, Lock function prevents overlay.
K3 Band and Mode, RIT/XIT/SPLIT and LOCK controlled from the program or the K3.

V2 NEW: Access to many of the K3 front panel controls with the click of your mouse. 

Frequency memory database.  Captures frequency and mode from the K3. Add notes and store. List can be sorted by frequency or mode or your notes.

K3 RX and TX equalizer database. Get and Set the K3 equalizers, grabs MIC Gain and Compression on applicable modes.  Add notes and save the settings.

General K3 Information.  Displays basic information about your K3 and it's configuration.

General Configuration.  The CONFIG entries that are common to RX and TX. Easily access the specific CONFIG entry in the K3 with a mouse click.

Receiver Configuration.  The CONFIG entries that are specific to RX functions. Easily access the specific CONFIG entry in the K3 with a mouse click.

Transmitter Configuration.  The CONFIG entries that are specific to TX functions. Easily access the specific CONFIG entry in the K3 with a mouse click.

Built-in K2 Computer Control Command Utility.

Antenna Scan Function.

REQUIREMENTS:  Any Windows operating system with .NET FRAMEWORK 2.0 installed (visit WWW.MICROSOFT.COM for information on .NET Framework).  K3EZ will not operate under LP_Bridge, see K3EZ documentation. 

Email N2BC